PDA

View Full Version : First Dyno on TBird


thhodges
07-10-2003, 05:25 PM
Well I still can drive the TBird after the Dyno run's Nothing borke, took it up to 6k rmp. But vary dissappointed in the output.

I paid for two pulls and allowed to make a few adjustmens after the first pull. I also had the air/fuel readings. This was an addition ten bucks total with tax was 110.88. They are real help full and I will go back again after I make some other changes. One Of the problems I had was with the auto trans and AOD keeping it in 3rd and not down shifting, so my actual reading were probbly a little higher.

Here is the reading after the second run.

RWHP 232 @ 4600rmp
Torque 310 @ 3300rmp.

46 Cobra
07-11-2003, 07:51 AM
96 - 98 Cobras according to factory specifications

HP 305 @ 5800rmp
Torque 300 @ 4800rmp.

jerrymjr
07-11-2003, 04:51 PM
Thats not 305 at the tires though......
As I remember they (we?) used to dial in at about 265 RWHP

JSlimJeff
07-24-2003, 09:50 PM
Check out the post on My dyno runs on the L. There is some special measures when using a Auto Trans.....